Models / Stacked ring vase
Stacked ring vase
Ring vase: a vase of stacked rings threaded on two crossed core plates, its outline a smooth curve from the foot to the lip. Rings of the same size are one part, so the cut list stays short. The base cuts its own slots for the core's feet. A glass test tube or a dried posy goes inside. Made with ring_stack() from kerf/rings.
53 parts on 2 sheets, shown together. Each sheet has its own cut file.
Source
// Ring vase: a vase of stacked rings threaded on two crossed core plates,
// its outline a smooth curve from the foot to the lip. Rings of the same
// size are one part, so the cut list stays short. The base cuts its own slots
// for the core's feet. A glass test tube or a dried posy goes inside. Made
// with ring_stack() from kerf/rings.
/* [Vase] */
// Height
height = 150; // [90:5:260]
// Widest, at the belly
belly = 90; // [60:5:160]
// Where the belly is, from the foot up (0 to 1)
belly_at = 0.35; // [0.2:0.05:0.7]
// Neck and lip
neck = 50; // [40:5:120]
// The hole through every ring, for a glass tube
hole = 34; // [24:1:60]
/* [Material] */
$thickness = 3; // [2:0.5:6]
$kerf = 0.15; // [0:0.01:0.3]
/* [Hidden] */
use <kerf/rings>
$fn = 72;
$material = "plywood";
t = $thickness;
n = max(6, round(height / t));
// The outline through the foot, the belly, the neck and the lip
profile = spline_points([[0, belly * 0.7], [belly_at * n, belly], [0.8 * n, neck], [n - 1, neck * 1.12]], 8);
function width_at(k) = lookup(k, profile);
assert(neck > hole + 8, "Make the neck wider or the hole smaller");
step("Slide the two core plates together and stand them in the base")
part("Base", at = [0, 0, -t], slots = ["Vase core A", "Vase core B"]) circle(d = belly * 0.7 + 16);
// Each ring rounded to the nearest millimetre, so alike rings share a part
step("Thread the rings over the core, biggest at the belly, gluing each to the one below")
ring_stack([for (k = [0:n - 1]) round(width_at(k))], hole, name = "Vase");