// Ring vase: a vase of stacked rings threaded on two crossed core plates, // its outline a smooth curve from the foot to the lip. Rings of the same // size are one part, so the cut list stays short. The base cuts its own slots // for the core's feet. A glass test tube or a dried posy goes inside. Made // with ring_stack() from kerf/rings. /* [Vase] */ // Height height = 150; // [90:5:260] // Widest, at the belly belly = 90; // [60:5:160] // Where the belly is, from the foot up (0 to 1) belly_at = 0.35; // [0.2:0.05:0.7] // Neck and lip neck = 50; // [40:5:120] // The hole through every ring, for a glass tube hole = 34; // [24:1:60] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] /* [Hidden] */ use $fn = 72; $material = "plywood"; t = $thickness; n = max(6, round(height / t)); // The outline through the foot, the belly, the neck and the lip profile = spline_points([[0, belly * 0.7], [belly_at * n, belly], [0.8 * n, neck], [n - 1, neck * 1.12]], 8); function width_at(k) = lookup(k, profile); assert(neck > hole + 8, "Make the neck wider or the hole smaller"); step("Slide the two core plates together and stand them in the base") part("Base", at = [0, 0, -t], slots = ["Vase core A", "Vase core B"]) circle(d = belly * 0.7 + 16); // Each ring rounded to the nearest millimetre, so alike rings share a part step("Thread the rings over the core, biggest at the belly, gluing each to the one below") ring_stack([for (k = [0:n - 1]) round(width_at(k))], hole, name = "Vase");