// Tea pavilion: a packet dispenser with a plain gable roof and a front lip. // Packet width, depth and stack height generate the enclosure dimensions. // Assembly: glue the wall and floor joints, then glue one roof slope in // place. Leave the other slope loose for refilling from above. /* [Packets] */ packet_width = 65; // [50:1:95] packet_depth = 60; // [45:1:90] stack_height = 160; // [90:5:250] ease = 4; // [2:0.5:8] opening_height = 24; // [18:1:36] /* [Roof] */ roof_rise = 34; // [22:2:60] overhang = 8; // [4:1:15] window_detail = true; /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] /* [Hidden] */ $material = "plywood"; t = $thickness; w = packet_width + 2 * ease + 2 * t; d = packet_depth + 2 * ease + 2 * t; h = stack_height + t; angle = atan(2 * roof_rise / w); slant = w / 2 / cos(angle); extra = overhang / cos(angle); assert(opening_height < h / 2, "Dispensing opening must stay below mid-height"); module end(front = false) { difference() { union() { finger_rect([w, h], ["in", "out", "flat", "out"]); polygon([[0, h - 0.1], [w, h - 0.1], [w / 2, h + roof_rise]]); } if (front) translate([w * 0.16, t + 6]) rect([w * 0.68, opening_height], r = 5); } if (window_detail) score() translate([w / 2, h * 0.65]) { outline() rect([w * 0.34, h * 0.22], center = true, r = 3); line([-w * 0.17, 0], [w * 0.17, 0]); line([0, -h * 0.11], [0, h * 0.11]); } } step("Glue the ends and sides into the floor") { part("Floor", at = [0, 0, 0]) finger_rect([w, d], "out"); part("Dispensing end", at = [0, t, 0], rotate = [90, 0, 0]) end(true); part("Rear end", at = [0, d, 0], rotate = [90, 0, 0]) end(false); part("Side", qty = 2, at = [[0, 0, 0], [w - t, 0, 0]], rotate = [90, 0, 90]) finger_rect([d, h], ["in", "in", "flat", "in"]); } step("Glue one roof slope in place") part("Fixed roof", at = [-overhang, -overhang, h - overhang * tan(angle)], rotate = [0, -angle, 0]) rect([slant + extra, d + 2 * overhang]); step("Lay the other slope on top, loose for refilling") part("Lift-off roof", at = [w / 2, -overhang, h + roof_rise], rotate = [0, angle, 0]) rect([slant + extra, d + 2 * overhang]);