// Slat roll: a flexible desk mat assembled from repeated rigid wooden slats. // Align the slats with the specified gap and lace two cords through their // paired holes. Leave the spans between slats free to hinge; knot the ends. // The curl control shows a bending pose, not an elastic-material simulation. /* [Mat] */ width = 230; // [150:5:350] slats = 24; // [12:1:36] slat_width = 10; // [8:1:16] gap = 1.5; // [1:0.1:3] cord_diameter = 1.5; // [1:0.1:2] curl = 0.7; // [0:0.05:1] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] /* [Hidden] */ $material = "plywood"; t = $thickness; pitch = slat_width + gap; arc_length = (slats - 1) * pitch; radius = curl == 0 ? 1000000 : arc_length / (curl * 270 * PI / 180); assert(curl >= 0 && curl <= 1, "Curl must stay between the flat and maximum rolled poses"); assert(gap > 2 * t * sin(135 / (slats - 1)) + 0.15, "Increase gaps or slat count for the curled thickness"); assert(slat_width > 2 * cord_diameter + 4, "Widen the slats for the lacing holes"); function a(i) = curl * 270 * i / (slats - 1); function centre(i) = curl == 0 ? [0, i * pitch, 0] : [0, radius * sin(a(i)), radius * (1 - cos(a(i)))]; function at_hole(i, x, v, z) = centre(i) + [x, v * cos(a(i)) - z * sin(a(i)), v * sin(a(i)) + z * cos(a(i))]; part("Laced slat", qty = slats, at = [for (i = [0:slats - 1]) centre(i)], rotate = [for (i = [0:slats - 1]) [a(i), 0, 0]]) difference() { rect([width, slat_width], center = true, r = 2); for (x = [-0.32 * width, 0.32 * width], y = [-slat_width / 4, slat_width / 4]) translate([x, y]) circle(d = cord_diameter + 0.8); } // Each cord runs across the back of a slat, over the gap on the front, // and through both holes for (i = [0:slats - 1], x = [-0.32 * width, 0.32 * width]) { hardware("cord", at_hole(i, x, -slat_width / 4, -0.3), at_hole(i, x, slat_width / 4, -0.3), cord_diameter, sides = 12); if (i < slats - 1) hardware("cord", at_hole(i, x, slat_width / 4, t + 0.3), at_hole(i + 1, x, -slat_width / 4, t + 0.3), cord_diameter, sides = 12); for (v = [-slat_width / 4, slat_width / 4]) hardware("cord", at_hole(i, x, v, -0.3), at_hole(i, x, v, t + 0.3), cord_diameter, sides = 12); }