// Pen tray: a desk tray whose round-bottomed trough is one strip of // plywood bent by a living hinge, between two end plates. The strip's tabs // go through slots in the ends, which the ends cut for themselves from // where the strip passes through them. Made with flex_strip() from // kerf/hinge. /* [Tray] */ // Length, end to end inside length = 200; // [120:10:400] // Width of the trough inside width = 60; // [40:5:120] // Depth of the trough depth = 60; // [40:5:150] // Text on the ends; leave empty for none label = "PENS"; // 12 /* [Material] */ $thickness = 3; // [2:0.5:4] $kerf = 0.15; // [0:0.01:0.3] /* [Hidden] */ use $fn = 72; $material = "plywood"; t = $thickness; r = width / 2; assert(depth - r >= 22, "Make the trough deeper, for straight sides with tabs"); // The strip's middle line in an end plate: down one side, round the // bottom, up the other path = concat([[0, depth]], [for (a = [180:5:360]) [r, r] + r * [cos(a), sin(a)]], [[width, depth]]); // An end plate: round the trough with a rim, on a flat foot module end_plate() { offset(r = 4) offset(delta = 8) polygon(concat(path, [[width, depth + 0.01], [0, depth + 0.01]])); translate([-12, -12]) rect([width + 24, r + 12]); } module end_label() if (len(label) > 0) engrave() translate([r, -5]) text(label, size = 7, fit = width, halign = "center", valign = "center"); step("Push the strip's tabs into one end, bending it round the bottom") { part("End A", at = [0, 0, 0], rotate = [90, 0, 0], slots = ["Trough"]) { end_plate(); end_label(); } place(rotate = [90, 0, 0]) flex_strip(path, length, name = "Trough"); } // The far end turned round to face out, its label reading from outside step("Press the other end on") part("End B", at = [width, length, 0], rotate = [90, 0, 180], slots = ["Trough"]) { end_plate(); end_label(); }