// Napkin bridge: two scooped cheeks stand in a slotted rectangular foot. // The clear gap follows the napkin stack, rather than a fixed sheet size. // Assembly: glue both cheeks into the foot after checking the slot fit. use /* [Holder] */ width = 170; // [100:5:260] height = 88; // [55:5:140] clear_gap = 40; // [20:5:90] scoop = 18; // [0:1:30] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] clearance = 0.15; // [0:0.05:0.4] /* [Hidden] */ $material = "plywood"; t = $thickness; depth = clear_gap + 2 * t + 24; centres = [12 + t / 2, 12 + 1.5 * t + clear_gap]; step("Lay the foot flat and check the slot fit") part("Foot", at = [0, 0, 0]) difference() { rect([width, depth], r = 5); for (y = centres) translate([8, y]) slots(width - 16, clearance = clearance); } step("Glue both cheeks into the foot") part("Cheek", qty = 2, at = [for (y = centres) [8, y + t / 2, t]], rotate = [90, 0, 0]) difference() { union() { rect([width - 16, height], r = 4); tabs(width - 16); } if (scoop > 0) translate([(width - 16) / 2, height]) ellipse([(width - 16) * 0.3, scoop]); }