> Canonical HTML: https://kerfscript.mylasertools.com/models/napkin-bridge/

# Napkin bridge

Napkin bridge: two scooped cheeks stand in a slotted rectangular foot. The clear gap follows the napkin stack, rather than a fixed sheet size. Assembly: glue both cheeks into the foot after checking the slot fit.

This design has 3 parts on 1 sheet. Customize it in the [playground](https://kerfscript.mylasertools.com/playground/?model=napkin-bridge).

## Downloads

- [KerfScript source](https://kerfscript.mylasertools.com/models/napkin-bridge/napkin-bridge.kerf)
- [SVG](https://kerfscript.mylasertools.com/models/napkin-bridge/napkin-bridge.svg)
- [DXF](https://kerfscript.mylasertools.com/models/napkin-bridge/napkin-bridge.dxf)

## Parts

| Part | Quantity | Size |
| --- | ---: | --- |
| Foot | 1 | 170 × 70 mm |
| Cheek | 2 | 154 × 91 mm |

## Settings

| Name | Default | Range or choices |
| --- | --- | --- |
| `width` | `170` | 100 to 260 |
| `height` | `88` | 55 to 140 |
| `clear_gap` | `40` | 20 to 90 |
| `scoop` | `18` | 0 to 30 |
| `$thickness` | `3` | 2 to 6 |
| `$kerf` | `0.15` | 0 to 0.3 |
| `clearance` | `0.15` | 0 to 0.4 |

## Source

```kerf
// Napkin bridge: two scooped cheeks stand in a slotted rectangular foot.
// The clear gap follows the napkin stack, rather than a fixed sheet size.
// Assembly: glue both cheeks into the foot after checking the slot fit.

use <kerf/tabs>

/* [Holder] */
width = 170; // [100:5:260]
height = 88; // [55:5:140]
clear_gap = 40; // [20:5:90]
scoop = 18; // [0:1:30]

/* [Material] */
$thickness = 3; // [2:0.5:6]
$kerf = 0.15; // [0:0.01:0.3]
clearance = 0.15; // [0:0.05:0.4]

/* [Hidden] */
$material = "plywood";
t = $thickness;
depth = clear_gap + 2 * t + 24;
centres = [12 + t / 2, 12 + 1.5 * t + clear_gap];
step("Lay the foot flat and check the slot fit")
  part("Foot", at = [0, 0, 0]) difference() {
    rect([width, depth], r = 5);
    for (y = centres) translate([8, y]) slots(width - 16, clearance = clearance);
  }
step("Glue both cheeks into the foot")
  part("Cheek", qty = 2, at = [for (y = centres) [8, y + t / 2, t]], rotate = [90, 0, 0]) difference() {
    union() { rect([width - 16, height], r = 4); tabs(width - 16); }
    if (scoop > 0) translate([(width - 16) / 2, height]) ellipse([(width - 16) * 0.3, scoop]);
  }
```

Set power, speed and cut order in your laser software. See the [laser software guide](https://kerfscript.mylasertools.com/docs/compatibility/index.md).
