// Miniature bench: a small seat and back tab into two shaped side supports. // This is a display miniature. Dimensions are not a human seating design. // Assembly: fit the seat and back between the sides, then glue the joints. use /* [Bench] */ width = 150; // [80:5:240] depth = 58; // [40:2:90] seat_height = 40; // [25:2:65] back_height = 47; // [25:2:75] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] clearance = 0.15; // [0:0.05:0.4] /* [Hidden] */ $material = "plywood"; t = $thickness; span = width - 2 * t; back_at = depth - 1.5 * t; total = seat_height + t + back_height + 7; step("Stand the two side supports up") part("Side support", qty = 2, at = [[0, 0, 0], [width - t, 0, 0]], rotate = [90, 0, 90]) difference() { polygon([[0, 0], [depth, 0], [depth, total], [depth - 12, total], [depth - 12, seat_height + 14], [0, seat_height + 14]]); translate([0, seat_height + t / 2]) slots(depth, clearance = clearance); translate([back_at, seat_height + t]) rotate(90) slots(back_height, clearance = clearance); translate([depth / 2, 8]) rect([depth - 24, 16], center = true, r = 3); } step("Fit the seat and back between the sides and glue the joints") { part("Seat", at = [t, 0, seat_height]) tab_rect([span, depth], [false, true, false, true]); part("Back", at = [t, back_at + t / 2, seat_height + t], rotate = [90, 0, 0]) difference() { tab_rect([span, back_height], [false, true, false, true]); for (j = [1:2]) translate([10, back_height * j / 3 - 1.5]) rect([span - 20, 3], r = 1.5); } }