// Calibration set: cut it once for every new material, before anything
// that has to fit. The kerf gauge measures the beam, the slot gauge how
// wide a slot your sheet needs, and the joint pairs which kerf setting
// makes finger joints that hold.

use <kerf/calibration>

/* [Tests] */
// Which pieces to cut
pieces = "all"; // [all:All three, kerf:Kerf gauge, slots:Slot gauge, joints:Joint pairs]
// Strips in the kerf gauge
strips = 10; // [5:1:20]
// Kerf settings to try on the joint pairs
kerfs = [0.1, 0.15, 0.2];

/* [Material] */
// Sheet thickness, as you measured it
$thickness = 3; // [1:0.5:10]

/* [Hidden] */
$material = "plywood";

if (pieces == "all" || pieces == "kerf") part("kerf gauge") kerf_gauge(strips);
if (pieces == "all" || pieces == "slots") part("slot gauge") slot_gauge();
if (pieces == "all" || pieces == "joints") joint_test(kerfs);