// Cable harbour: a divided device tray with cable exits through its back. // Bay width, count and cable diameter generate the internal layout. // Assembly: glue the box, then fit the dividers without glue for cleaning. use use /* [Devices] */ bays = 3; // [1:1:6] bay_width = 27; // [20:1:45] depth = 145; // [90:5:230] wall_height = 44; // [30:2:70] divider_height = 65; // [45:5:100] cable_diameter = 8; // [5:1:14] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] clearance = 0.15; // [0:0.05:0.4] /* [Hidden] */ $material = "plywood"; t = $thickness; w = bays * bay_width + (bays + 1) * t; part("Floor", at = [0, 0, 0]) difference() { finger_rect([w, depth], "out"); if (bays > 1) for (i = [1:bays - 1]) translate([i * (bay_width + t) + t / 2, t + 0.5]) rotate(90) slots(depth - 2 * t - 1, clearance = clearance); } step("Glue the front, the cable wall and the ends to the floor") { part("Front", at = [0, t, 0], rotate = [90, 0, 0]) finger_rect([w, wall_height], ["in", "out", "flat", "out"]); part("Cable wall", at = [0, depth, 0], rotate = [90, 0, 0]) difference() { finger_rect([w, wall_height], ["in", "out", "flat", "out"]); for (i = [0:bays - 1]) translate([t + bay_width / 2 + i * (bay_width + t), wall_height]) rect([cable_diameter, wall_height * 0.66], center = true, r = cable_diameter / 2); } part("End", qty = 2, at = [[0, 0, 0], [w - t, 0, 0]], rotate = [90, 0, 90]) finger_rect([depth, wall_height], ["in", "in", "flat", "in"]); } step("Fit the device dividers into the floor slots, without glue") if (bays > 1) part("Device divider", qty = bays - 1, at = [for (i = [1:bays - 1]) [i * (bay_width + t), t + 0.5, t]], rotate = [90, 0, 90]) union() { rect([depth - 2 * t - 1, divider_height], r = 4); tabs(depth - 2 * t - 1); }