// Cable chain: alternating wide and narrow U-links pivot on bought side bolts. // Each link has two cheeks and one tabbed floor bridge. The channel stays open. // Assembly: glue each U-link square, then connect adjacent cheeks with short // bolts, washers and locknuts. Keep the pivots loose enough to turn freely. // This free-pivot prototype has no mechanical bend stops or machine rating. use /* [Chain] */ links = 8; // [3:1:14] channel_width = 28; // [18:1:60] link_height = 22; // [20:1:40] pitch = 36; // [32:1:65] pin_diameter = 3; // [3:0.5:5] /* [Assembled view] */ // Angle between successive links; this does not add a physical stop. joint_angle = 8; // [0:1:12] /* [Material] */ $thickness = 3; // [2:0.5:6] $kerf = 0.15; // [0:0.01:0.3] clearance = 0.15; // [0:0.05:0.4] pivot_clearance = 0.3; // [0.2:0.05:0.6] axial_gap = 0.5; // [0.3:0.1:1] /* [Hidden] */ $material = "plywood"; t = $thickness; r = link_height / 2; bridge_length = pitch - 2 * (r + 2); floor_z = -r + 3; assert(bridge_length >= 8, "Increase pitch or reduce link height"); assert(link_height > 2 * t + 10, "Increase link height for this thickness"); assert(pin_diameter + pivot_clearance < link_height - 10, "Pivot holes leave too little material"); assert((links - 1) * joint_angle <= 150, "Reduce bend or link count to avoid curling back"); function joint(i) = [i == 0 ? 0 : sum([for (j = [0:i - 1]) pitch * cos(j * joint_angle)]), 0, r + (i == 0 ? 0 : sum([for (j = [0:i - 1]) pitch * sin(j * joint_angle)]))]; function direction(a) = [cos(a), 0, sin(a)]; function normal(a) = [-sin(a), 0, cos(a)]; module cheek() difference() { hull() { circle(r = r); translate([pitch, 0]) circle(r = r); } for (x = [0, pitch]) translate([x, 0]) circle(d = pin_diameter + pivot_clearance); translate([pitch / 2, floor_z + t / 2]) rect([bridge_length / 2 + clearance, t + clearance], center = true); } for (i = [0:links - 1]) { a = i * joint_angle; span = channel_width + (i % 2 == 0 ? 0 : 2 * (t + axial_gap)); for (side = [-1, 1]) part(str("Link ", i + 1, side < 0 ? " left cheek" : " right cheek"), at = joint(i) + [0, side * (span / 2 + t / 2) + t / 2, 0], rotate = [90, -a, 0]) cheek(); part(str("Link ", i + 1, " bridge"), at = joint(i) + direction(a) * (pitch / 2 + bridge_length / 2) + normal(a) * floor_z + [0, -span / 2, 0], rotate = [-a, 0, 90]) tab_rect([span, bridge_length], [false, true, false, true], count = 1, width = bridge_length / 2); }