// Bottle tote: a compartment tray with a tall central handle partition. // Bottle diameter and column count generate the footprint and handle span. // Assembly: glue all joints and the handle partition to the floor. Use for // light display bottles until the chosen material and joints are load tested. use /* [Bottles] */ bottle_diameter = 65; // [45:1:90] columns = 2; // [2:1:4] ease = 4; // [2:1:8] wall_height = 65; // [45:5:100] handle_height = 185; // [140:5:240] /* [Material] */ $thickness = 4; // [3:0.5:6] $kerf = 0.15; // [0:0.01:0.3] clearance = 0.15; // [0:0.05:0.4] /* [Hidden] */ $material = "plywood"; t = $thickness; pitch = bottle_diameter + 2 * ease + t; w = columns * pitch + t; d = 2 * pitch + t; inner = w - 2 * t; slot_h = wall_height - t - 3; assert(handle_height > wall_height + 55, "Handle needs room above the compartments"); part("Floor", at = [0, 0, 0]) difference() { finger_rect([w, d], "out"); translate([t, d / 2]) slots_for_handle(); } // Two short tabs locate the handle in the floor, avoiding its cross slots. module slots_for_handle() { for (x = [inner * 0.2, inner * 0.8]) translate([x, 0]) rect([14 + clearance, t + clearance], center = true); } step("Glue the long walls and end walls to the floor") { part("Long wall", qty = 2, at = [[0, t, 0], [0, d, 0]], rotate = [90, 0, 0]) finger_rect([w, wall_height], ["in", "out", "flat", "out"]); part("End wall", qty = 2, at = [[0, 0, 0], [w - t, 0, 0]], rotate = [90, 0, 90]) finger_rect([d, wall_height], ["in", "in", "flat", "in"]); } step("Stand the cross dividers on the floor and lower the handle partition over them, tabs into the floor") { part("Handle partition", at = [t, d / 2 + t / 2, t], rotate = [90, 0, 0]) difference() { union() { rect([inner, handle_height], r = 8); for (x = [inner * 0.2, inner * 0.8]) translate([x - 7, -t]) rect([14, t + 0.1]); } translate([inner / 2, handle_height - 25]) rect([min(95, inner - 30), 25], center = true, r = 10); for (i = [1:columns - 1]) translate([i * pitch - t / 2 - (t + clearance) / 2, -1]) rect([t + clearance, slot_h / 2 + 1]); } part("Cross divider", qty = columns - 1, at = [for (i = [1:columns - 1]) [i * pitch, t + 0.5, t]], rotate = [90, 0, 90]) slotted_divider(d - 2 * t - 1, slot_h, [d / 2 - t - 0.5], "top", clearance); }